How to Replace Bentgo Kids Water Bottle Straws: A Step-by-Step Guide

Kids love their Bentgo water bottles, but straws can get chewed, lost, or just wear out over time. Replacing the straw is a simple fix that can extend the life of the bottle and keep your child drinking happily. This guide walks you through the process, whether you have a standard straw or a replacement straws 2-pack handy.

Before you start, gather the new straw and a clean cloth. Most Bentgo Kids bottles, like the ones included with the Bentgo Kids Stainless Steel Lunch Box or the Bentgo Kids Prints Lunch Boxes & Water Bottles, use a similar straw mechanism. Knowing how to fix bentgo straw issues will save you money and reduce waste.

Step 1: Remove the Old Straw

Start by unscrewing the bottle cap completely. Pull the old straw straight out of the cap's straw port. If it's stuck, gently twist while pulling. Inspect the straw port for any debris or damage. Discard the old straw.

For bottles that have a bite valve or silicone tip, remove that as well by pulling it off the straw. This makes cleaning easier and ensures you install the new straw correctly.

• Check the straw port for cracks before inserting a new straw.

Step 2: Clean the Cap and Bottle

Before installing the new straw, take a moment to clean the bottle cap and the bottle itself. Use warm soapy water and a bottle brush to scrub the inside of the cap, especially the straw port and the threading. Rinse thoroughly.

Regular maintenance helps prevent mold and keeps the bottle fresh. If you're replacing straws due to wear, it's also a good time to deep clean the entire bottle. The Bentgo Kids Stainless Steel Insulated Water Bottle is dishwasher safe, but hand washing the cap is recommended to preserve the seal.

• Use a small brush to clean the straw port inside the cap.

Step 3: Install the New Straw

Take your new replacement straw (often sold as a Bentgo replacement straws 2-pack) and push it firmly into the straw port on the underside of the cap. Ensure it goes all the way in until it seats securely. If your bottle uses a bite valve, attach it to the top end of the straw.

Some straws are slightly longer and need to be trimmed. Check that the straw reaches the bottom of the bottle when the cap is screwed on. If it's too long, use clean scissors to trim it to size. A properly fitted straw prevents air leaks and makes drinking easier.

• Trim the straw if it sticks out too far from the cap.

Step 4: Test for Leaks and Function

Screw the cap back onto the bottle, making sure it's tight. Fill the bottle with water, turn it upside down, and check for leaks around the cap and straw. If water drips from the straw port, the straw may not be seated correctly or the cap seal may need replacement.

Have your child test the straw by drinking. If they have to suck hard, the straw might be kinked or blocked. Remove the cap and check the straw's alignment. A smooth flow means the installation is successful.

• Check the silicone gasket on the cap for wear if leaks persist.

Replacing the straw on a Bentgo Kids water bottle is a quick DIY fix that keeps the bottle in daily rotation. With a replacement straws 2-pack on hand, you can swap out worn straws in minutes. Regular cleaning and prompt replacement will keep your child's bottle hygienic and leak-free for many school years.